Drive System Maintenance; Checking The Tire Pressure; Torquing The Wheel Nuts; Adjusting The Traction Drive For Neutral - Toro Reelmaster 3100-D Operator's Manual

4. Assemble the cover onto the control arm
75).
Drive System
(Figure
Maintenance

Checking the Tire Pressure

Service Interval: Before each use or daily
DANGER
Low tire pressure decreases machine side hill
stability. This could cause a rollover, which
may result in personal injury or death.
Do not under-inflate the tires.
Note:
Maintain the recommended pressure in all tires
to ensure a good quality of cut and proper machine
performance.
1. Measure the air pressure in each tire. The
correct air pressure in the tires is 97 to 110 kPa
(14 to 16 psi).
2. If needed, add air to of remove air from the tires
until you measure 97 to 110 kPa (14 to 16 psi).

Torquing the Wheel Nuts

Service Interval: After the first hour
After the first 10 hours
Every 200 hours
Torque the wheel nuts in a crossing pattern to 61 to
88 N∙m (45 to 65 ft-lb).
WARNING
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Ensure that the wheel nuts are torqued to 61
to 88 N∙m (45 to 65 ft-lb).
Adjusting the Traction
Drive for Neutral
If the machine moves when the traction pedal is in the
N position, adjust the traction cam.
EUTRAL
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key from the ignition
switch.
2. Raise a front wheel and a rear wheel off the floor
and place support blocks under the frame.
53