Brother MFC-J1300DW Online User's Manual page 490

Error Message
Comm.Error
Connection Error
Connection Failed
Cover is Open.
Data Remaining in
Memory
Disconnected
Document Jam/too Long
DR Mode in Use
FaxAbility On
High Temperature
Cause
Poor telephone line quality caused a
communication error.
Other devices are trying to connect to the
Wi-Fi Direct network at the same time.
The Brother machine and your mobile
device cannot communicate during the
Wi-Fi Direct network configuration.
The scanner cover is not locked in the
closed position.
The ink cartridge cover is not locked in the
closed position.
Print data is left in the machine's memory. Press
The other person or other person's fax
machine stopped the call.
The document was not inserted or fed
correctly, or the document scanned from
the ADF was too long.
The machine is in Distinctive Ring mode.
You cannot change the Receive Mode
from Manual to another mode.
The machine is in FaxAbility mode. You
cannot change the Receive Mode from
Manual to another mode.
The room temperature is too high.
Action
remains, contact Brother customer service
or your local Brother dealer.
Send the fax again or connect the
machine to another telephone line. If the
problem continues, contact the telephone
company and ask them to check your
telephone line.
Make sure there are no other devices
trying to connect to the Wi-Fi Direct
network, and then try to configure the Wi-
Fi Direct settings again.
• Move the mobile device closer to your
Brother machine.
• Move your Brother machine and the
mobile device to an obstruction-free
area.
• If you are using the PIN Method of
WPS, make sure you have entered the
correct PIN.
Lift the scanner cover and then close it
again.
Make sure the interface cable (if used)
has been guided correctly through the
cable channel and out the back of the
machine.
Firmly close the ink cartridge cover until it
locks into place.
. The machine will cancel the
job and clear it from the memory. Try to
print again.
Try to send or receive again.
If calls are stopped repeatedly and you
are using a VoIP (Voice over IP) system,
try changing the Compatibility to Basic (for
VoIP).
See Related Information: Telephone Line
Interference/VoIP.
Remove the jammed document, and then
press . Set the document in the ADF
correctly.
See Related Information: Load
Documents in the Automatic Document
Feeder (ADF).
See Related Information: Document
Jams.
Set Distinctive Ring to Off.
See Related Information: Turn off
Distinctive Ring.
Set FaxAbility to Off.
See Related Information: Turn FaxAbility
Off or On.
After cooling the room, allow the machine
to cool down to room temperature. Try
483