Advertisement
Safety rules
Pay attention to this symbol
This warning symbol points out important messages con-
cerning your safety.
Carefully read the following safety regulations and ob-
serve advised precautions in order to avoid potential haz-
ards and safeguard your health and safety.
In this manual the symbol is accompanied by the following
key-words:
WARNING: Warnings concerning unsuitable repair oper-
ations that may jeopardise the safety of Repair personnel.
DANGER: Specific warnings concerning potential haz-
ards for operator safety or for other persons directly or
indirectly involved.
To prevent accidents
Most accidents or injuries that occur in workshops are the result of non-observance of simple and fundamental safety
regulations. For this reason, IN MOST CASES THESE ACCIDENTS CAN BE AVOIDED by foreseeing possible
causes and consequently acting with the necessary caution and care.
Accidents may occur with all types of vehicle, regardless of how well it was designed and built.
A careful and judicious service technician is the best guarantee against accidents.
Precise observance of the most basic safety rule is normally sufficient to avoid many serious accidents.
DANGER: Never carry out any cleaning, lubrication or maintenance operations when the engine is running.
Safety rules
General guidelines:
• Carefully follow specified repair and maintenance procedures.
• Do not wear rings, wristwatches, jewels, unbuttoned or flapping clothing such as ties, torn clothes, scarves, open
jackets or shirts with open zips which could get caught on moving parts.
Use approved safety clothing such as anti-slipping footwear, gloves, safety goggles, helmets, etc.
• Do not carry out repair operations with someone sitting in the driver's seat, unless the person is a trained technician
who is assisting with the operation in question.
• Do not operate the vehicle or use any of the implements from different positions, other than the driver's seat.
• Do not carry out operations on the vehicle with the engine running, unless specifically indicated.
• Stop the engine and ensure that all pressure is relieved from hydraulic circuits before removing caps, covers, valves,
etc.
• All repair and maintenance operations must be carried out using extreme care and attention.
• Service steps and platforms used in a workshop or in the field should be built in compliance with the safety rules in
force.
• Disconnect the batteries and label all controls to indicate that the vehicle is being serviced. Block the machine and
all equipment which should be raised.
• Do not check or fill fuel tanks, accumulator batteries, nor use starting liquid when smoking or near naked flames,
as these fluids are inflammable.
• Brakes are inoperative when manually released for repair or maintenance purposes. Use blocks or similar devices
to control the machine in these conditions.
INTRODUCTION
51553302 19/11/2018
3
Find manuals at https://best-manuals.com
1
ANIL15TR0707AA
Advertisement
