Installing an Optional Mini-GBIC
2. Remove the Mini-GBIC from the packaging.
3. If there is a protective dust cover (see 5 in
not remove it at this time.
Installation
To install a Mini-GBIC with an MT-RJ connection, refer to
to
Figure
3-2, or for an RJ45 connection, refer to
1. Hold the Mini-GBIC with its top side facing up and its 7-pin edge connector facing the port
slot .
2. Carefully align the Mini-GBIC with the port slot .
3. Push the Mini-GBIC into the port slot until the Mini-GBIC "clicks" and locks into place.
Figure 3-1 Mini-GBIC with MT-RJ Connector
1 Mini-GBIC (MGBIC-MT01)
,
2 Mini-GBIC
top side
3 7-Pin edge connector (insertion side)
3-4
Installation
Figure 3-1
or
Figure
Figure
Figure
3-3, and proceed as follows:
4 Port slot
,
5 Mini-GBIC
protective dust cover
6 Release tab
3-2) on the Mini-GBIC port, do
3-1, for an LC connection, refer