Viessmann Vitosol-F Installation Instructions For Contractors page 5

Intended use
(cont.)
Any usage beyond this must be approved by the man-
ufacturer in each individual case.
Incorrect usage of the collectors or the installation sys-
tem or incorrect operation is prohibited (e.g. the collec-
tors being opened by the system user, failure to
observe the installation instructions). Failure to
observe these instructions can change functions,
endanger life and limb of the user or third parties and
will result in an exclusion of liability.
Product information
Vitosol 100-F, 200-F, -FM and 300-F, type SV and SH,
are high performance flat-plate collectors.
The fixing system, with structurally tested and corro-
sion-resistant components made from stainless steel
and aluminium, is easy to install.
Collector support standard set and collector support extension
■ Standard set: 2 collector supports
■ Extension: 1 collector support
Fig. 1
Collector support with footplates
1
Washer 8.4 mm
2
7
Hexagon bolt M 8 x 25
3
1 2 3
Incorrect usage also applies if components in the sys-
tem are modified from their intended use (e.g. through
direct DHW heating in the collector).
Adhere to statutory regulations, especially concerning
the hygiene of potable water.
The following component assemblies are available for
collector types SV and SH, for a 30°, 45° or 60° angle
of collector inclination.
4 5
Clamping bracket
4
Self-tapping screw
5
5