Front View Of The Bladecenter S Chassis - IBM BladeCenter S Problem Determination And Service Manual

Front view of the BladeCenter S chassis

Blade servers, storage modules, and the media tray are installed in the front of the
BladeCenter S chassis.
Note: For proper cooling, each bay in the BladeCenter S chassis must have either a
device or a filler installed.
The following illustration shows the front of the BladeCenter S chassis.
Storage
module
Storage modules
You can install a maximum of two storage modules in the BladeCenter S chassis
and each storage module contains hot-swap hard disk drives. A storage module
and the hard disk drives installed in that storage module are commonly referred to
as integrated shared storage because this storage is integrated in the BladeCenter S
chassis and shared among the blade servers in the BladeCenter S system.
Each storage module can support up to six hot-swap, 3.5-inch hard disk drives. If
you are installing SAS connectivity modules, both SAS and SATA hard disk drives
are supported, and you can use both types of hard disk drives in each storage
module. If you are installing SAS RAID controller modules, you must install SAS
hard disk drives.
Within each storage module, hard disk drives are numbered 1 through 6 from left
to right, and top to bottom.
Note: Each hard disk drive bay must contain either a hard disk drive or a
drive-bay filler.
6
BladeCenter S Type 7779/8886: Problem Determination and Service Guide
Battery backup
unit 1
1
SAS/SATA
hard disk drives
Media tray
Blades
Battery backup SAS/SATA
unit 2 hard disk drives
Storage
module
2