Removing A Midplane-To-Fan Cable - IBM BladeCenter S Problem Determination And Service Manual

Removing a midplane-to-fan cable

The removal of a midplane-to-fan cable should only be performed by a trained
service technician.
Before you begin
Read "Safety" on page v and "Installation guidelines" on page 73 before
performing this procedure.
About this task
There are four midplane-to-fan cables in the BladeCenter S chassis.
Procedure
1. Remove the SPC chassis (shuttle) from the BladeCenter S chassis (see
2. Remove the midplane from the SPC chassis (see "Removing the midplane" on
3. Remove the midplane-to-fan cable from the midplane.
4. Remove the midplane-to-fan cable from the BladeCenter S chassis.
106
BladeCenter S Type 7779/8886: Problem Determination and Service Guide
"Removing the SPC chassis (shuttle)" on page 100).
page 103).
a. Disconnect the midplane-to-fan cable plug from the midplane connector.
b. Remove the fan cable cover.
c. Push the cable plug back down through the fan cable hole in the SPC
chassis.
Fan cable cover