Toe Adjustment - Polaris 2000 120 XCR Service Manual

BODY/STEERING

TOE ADJUSTMENT

1. With tape measure, measure from handlebar to a common
point on both sides of machine to center handlebars.
2. Make sure track is aligned correctly and place a straight rod
tightly against track. Take measurements at locations (1,2)
shown to determine if skis need alignment
1
2
5.4
3. If skis do not measure equally, loosen tie rod end jam nuts
(inner and outer) and turn tie rod until equal measurements
are achieved.
4. Once you have skis in straight ahead position, measure
from the straight edge of the skis. The measurement
between the skis at point 3 should be 1/8 inches greater than
point 4, as shown.
The measurement between the skis at point 7 should be
1/8" (3.175mm) greater than point 8, as shown below.
NOTE: This measurement should be taken with the
vehicle weight compressing the suspension.
3
4
5. Once you have achieved the above measurements, tighten
all tie rod jam nuts.
= In. / mm.