Polaris 2000 120 XCR Service Manual page 52

7. Remove cables from harness guide clips (J).
J
8. Disconnect the stop switch (K).
K
9. Remove the inner tie rod bolts (L).
10. Remove steering post fasteners (M).
M
ENGINE / CARBURETOR / CLUTCH
11. Remove the steering post.
12. Find master link on drive chain. Remove keeper and slide
13. Hold shoulder of clutch with adjustable pliers and remove
14. Free recoil rope from chassis. Be sure to tie knot in rope
15. Remove fuel line from fuel tank to carburetor. Have
16. Remove eight (8) motor mount bolts (N). Four are located
L
17. Remove engine by tilting engine toward PTO side and
master link out. Do not re-use master link. Always replace
with new. Remove the chain.
clutch bolt. Slide clutch off drive shaft.
upon removal from handle or rope will retract inside recoil
housing.
container or shop cloth ready to catch any spilled fuel.
at the base of the engine and protrude through bottom of
bulkhead. The other four are located on clutch side of
bulkhead as shown.
sliding engine to MAG side. Lift engine out.
4
N
4.13