Advertisement
STARTING AND STOPPING SAW
To turn the saw "ON" press in the safety button (A) Fig.7 and then pull the large
trigger switch (B). To turn the saw "OFF" release trigger switch.
LOCKING CUTTING ARM IN THE DOWN POSITION
When transporting the miter saw, the cutting arm should always be locked in the
down position. First fully lower the cutting arm, then pull and turn simultaneously
the head lock mechanism (A) Fig.8 until the locking pin is lined up with the gap
and release. It may be necessary to raise the cutting arm until the head lock shaft
locks the head into place.
ROTATING TABLE FOR MITER CUTTING
Your compound miter saw will cut any miter angle from a straight 90 degree
cut-off to 45 degrees right and left. Simply loosen table lock knob (A) Fig.9, press
the lock lever (B) down and turn the table using the table lock knob until the
pointer arrow (C) aligns with the desired setting on the miter scale (D). Then
retighten table lock knob (A).
TIGHTENED FOR ALL CUTTING OPERATIONS.
Your compound miter saw table contains positive stops at 0
45
0
right and left positions.
TILTING CUTTING ARM FOR BEVEL CUTTING
Loosen bevel cutting lock knob (A) Fig.10, tilt cutting arm to the desired bevel
angle and retighten lock knob (A). WARNING: LOCK KNOB (A) MUST BE
TIGHTENED DURING ALL CUTTING OPERATIONS.
The bevel angle of the cutting arm is determined by the position of the pointer (B)
Fig.10, on the scale (C).
OPERATING CONTROLS
WARNING: LOCK KNOB (A) MUST BE
, 15
0
, 22.5
, 30
and
0
0
0
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
Advertisement
