Onkyo TX-NR797 Instruction Manual page 140

Setting Item Default Value Setting Details
Height 1 0.0 dB After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with
Height 2 0.0 dB After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with
Surround 0.0 dB After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with
Surround Back 0.0 dB After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with
Subwoofer 0.0 dB After selecting the speaker frequency between
"25 Hz" and "160 Hz" with the cursors
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with
• Depending on the input source or listening mode setting, the desired effect may not be
achieved.
/ .
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
/ .
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
/ .
/ .
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
/ .
• This cannot be selected if "Configuration" -
"Subwoofer" is set to "No".
Contents Connections
≫
„ 7. THX Audio
Change the THX Audio settings.
/ , adjust
Setting Item
Back Speaker
Spacing
/ , adjust
/ , adjust
THX Ultra / Select
Subwoofer
/ , adjust
BGC
/ , adjust
140
Playback
≫
Default Value Setting Details
>4.0 ft/>1.2 m Select the distance between the surround back
speakers from "<1.0 ft/<0.3 m", "1.0 - 4.0 ft/0.3 -
1.2 m", and ">4.0 ft/>1.2 m".
• The unit of distance (ft/m) is displayed using the
unit selected for the "Distance" setting.
• The setting cannot be changed if "Configuration"
- "Zone Speaker" is set to a selection item other
than "No" and Zone 2 is on.
• If the item cannot be selected even though
connection is correct, check if the setting in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
No Set whether a THX-certified subwoofer is
connected or not.
"Yes": When a THX-certified subwoofer is
connected
"No": When a THX-certified subwoofer is not
connected
• The setting cannot be changed if "Configuration"
- "Subwoofer" is set to "No"
Off Correct an emphasized bass sound when listening
to music near the wall or boundary of the room due
to layout limitation of the listening room. The THX
Select receivers can adjust the balance of bass
sound.
"On": When this function is used
"Off": When this function is not used
• In the following cases, the setting cannot be
changed:
– "Configuration" - "Subwoofer" is set to "No".
– "THX Ultra / Select Subwoofer" is set to "No".
Front Panel≫ Rear Panel≫ Remote≫
Setup
≫ ≫