Onkyo TX-NR797 Instruction Manual page 139

Setting Item Default Value Setting Details
Height 2 Right 0.0 dB Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
• Depending on the use of the ZONE speakers, it
Surround Right 0.0 dB Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Surr Back Right 0.0 dB Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
• Depending on the use of the ZONE speakers, it
Surr Back Left 0.0 dB Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
• Depending on the use of the ZONE speakers, it
Surround Left 0.0 dB Select a value between "-12.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Subwoofer 0.0 dB Select a value between "-15.0 dB" and "+12.0 dB"
(in 0.5 dB increments). A test tone will be output
each time you change the value. Select the desired
level.
Contents
may not be possible to select this setting.
may not be possible to select this setting.
may not be possible to select this setting.
Connections
≫
„ 5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
Setting Item Default Value
Dolby Enabled 6.0 ft/1.80 m
Speaker to Ceiling
AccuReflex Off
• This setting can be selected when "Configuration" - "Height 1 Speaker"/"Height 2
Speaker" is set to "Dolby Speaker".
„ 6. Equalizer Settings
You can adjust the output volume of the range for each connected speaker.
Adjust the volume of different sound ranges for each speaker. You can set three
different equalizers in Preset 1 to 3. The number of frequencies that can be
selected for each speaker is up to five bands for the Subwoofer and nine bands
for the other speakers.
Setting Item Default Value
Front 0.0 dB
Center 0.0 dB
139
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Set the distance between the Dolby Enabled
Speaker and the ceiling. Select between
"0.1 ft/0.03 m" and "15.0 ft/4.50 m" (0.1 ft/0.03 m
units).
• The unit of distance (ft/m) is displayed using the
unit selected for the "Distance" setting.
You can enhance the reflection effect of Dolby
Enabled Speakers from the ceiling.
"Off": When this function is not used
"On": When this function is used
Setting Details
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
≫
/ , adjust
/ , adjust