Sound Attenuating Plinth - Viessmann KWT Vitocal 300-G Pro Installation And Service Instructions Manual

Preparing for installation
Siting
(cont.)
Minimum clearances
C D
600
B
E
Fig.3
C D C D
600 600
B
E
Fig.4

Sound attenuating plinth

Position the heat pump on a base prepared on site for
the purpose of noise attenuation and even weight dis-
tribution.
12
A
600
A
600
Clearance subject to on-site installation and loca-
A
tion
Clearance for installation and service (e.g. for
B
removing and cleaning the tubular heat exchang-
ers)
Type BW: 500 mm
■ ≥
Type WW: 2000 mm
■
≥
Cable entries:
C
On-site strain relief clamps required (wall clear-
ance ≥ 80 mm).
■ When using hydraulic connection accessories
D
(connection set and Victaulic flange adaptor set,
2 or 3 version):
½" "
1000 mm
≥
■ On-site hydraulic connections:
600 mm
≥
■ Without anti-vibration parts (side sections):
E
855 mm
≥
Note
When installing cascades (2 to 5 heat pumps), observe
the respective minimum clearances in accordance with
the preceding graphics.
Note
For corner installation, enlarge the base by the mini-
mum clearances (see chapter "Minimum clearances").