Resetting Filter Cleaning Alarm; On-Timer - Samsung MWR-SH11UN User Manual

Resetting filter cleaning alarm

When the appears on the remote controller, clean the filter and set the filter reset off in the user setting mode.
You can see how to access user setting mode at the page 18~19.
NOTE

On-timer

When an indoor unit is turned off,
Press the [ Timer ] button.
- Time segment will blink in 1 second period in setting mode.
- Press [ + ]/[ - ] button to adjust the time.
- Time is set by 30 minutes unit for less than 3 hours, and by 1 hour unit for more than 3 hours.
- Time can be set from 30 minutes to 24 hours maximum.
1. Press the [ OK ] button when time setting is completed. Time segment will stop blinking and remaining time
will decrease by 1 minute unit from set time.
- If there is no input during 3 minutes in setting mode, set time and the mode will be canceled.
2. Press and hold [ Cancel ] button for more than 3 seconds to cancel the setting mode without saving the
current setting.
3. Press and hold [ Cancel ] button for more than 3 seconds to cancel the on timer after setting is finished.
On timer function can be set only when an indoor unit is turned off.
NOTE
User Setting
Mode
ENGLISH-14