Power Grip™ Hand-Held Control - Blizzard 7600LT Owner's Manual

STRAIGHT BLADE POWER GRIP™
HAND-HELD CONTROL
WARNING
To prevent accidental movement of the blade,
always push the ON/OFF button to switch the
control OFF whenever the snowplow is not in
use. The power indicator light will turn OFF.
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position.
2. Press the ON/OFF button on the control. The
power indicator light glows red, indicating the
control is ON. The power indicator light glows
red whenever the control ON/OFF switch and the
vehicle ignition switch are both ON, the electrical
connections to the snowplow are completed
and the power switch on the light tower is in the
"PLOWING" position. If the power switch is in the
"OFF" position, the power indicator light will fl ash.
The ON/OFF button operates as an emergency
stop, if required.
Function Time-Outs
All control functions, except LOWER/FLOAT,
automatically time out (stop) after a period of time.
This helps prevent unnecessary battery drain.
NOTE: If control function times out before desired
blade movement is complete, release button and
press again.
Function Description of Operation
Press this button to turn the control ON and OFF. Turn the control OFF (power indicator
ON/OFF
light OFF) to lock the blade in place. This prevents accidental movement of the blade.
Press this button to raise snowplow and cancel FLOAT mode. Function times out after
RAISE
3.5 seconds.
Press this button to lower snowplow. Release button to stop blade at desired height.
LOWER
Press LOWER button and hold for 3/4 second to activate this mode. FLOAT light in upper
left corner of control face will illuminate. Blade will lower to ground surface and follow
contour of surface as it dips or raises. Function does not time out; however, control will shut
FLOAT
down after 20 minutes of nonuse.
Press RAISE button momentarily to cancel FLOAT. FLOAT will continue during Angle Left
and Angle Right functions if not interrupted by Raise function.
L Press this button to angle left position. Function times out after 3.5 seconds.
(Angle Left)
R Press this button to angle right position. Function times out after 3.5 seconds.
(Angle Right)
Lit. No. 40595, Rev. 05
OPERATING YOUR SNOWPLOW
Float Light
(green)
FLOAT
L
Automatic Shutdown
The control automatically turns OFF after being idle
for 20 minutes.
Smooth Stop
The control automatically allows the blade to coast to
a stop. This results in smoother operation, reduces the
shock to the hydraulic system and increases hose and
valve life.
Control Functions
Raise, Lower, Float, Angle
The four diamond-shaped buttons in the center of the
control face, when pressed, will result in the blade
movements described in the table.
19
Power Indicator
Light (red)
ON/OFF
RAISE
ON/OFF
Button
(emergency
R
stop)
LOWER
May 1, 2021