Table of Contents
Advertisement
SNOWPLOW HEADLAMP CHECK
With all electrical plugs connected, check the
operation of vehicle and snowplow headlamps.
Connecting and disconnecting the electrical plugs
should switch between the vehicle and snowplow
headlamps as follows:
• Electrical plugs DISCONNECTED—Vehicle
headlamps function normally.
• Electrical plugs CONNECTED—Vehicle headlamp
functions transfer to the snowplow headlamps.
On some Daytime Running Lamp (DRL) systems,
both the vehicle and snowplow headlamps will
function.
Aiming the Headlamps
• Aim the snowplow headlamps with the snowplow
mounted and raised in the transport position. See
Aiming Headlamp Beams in the Maintenance
section for instructions.
• Aim the vehicle headlamps with the snowplow
removed from the vehicle.
Lights
Parking Lamps
Right Turn Signal
Left Turn Signal
Lit. No. 40595, Rev. 05
OPERATING YOUR SNOWPLOW
Results
Both vehicle and snowplow
lamps should be ON.
Both vehicle and snowplow
lamps should be ON.
Both vehicle and snowplow
lamps should be ON.
DISC SHOE ADJUSTMENT
Blade can drop unexpectedly. Place blade on
stand assembly. Failure to do so could result
in serious personal injury.
Recommended Shoe Adjustments
For gravel surfaces: The bottom surface of the shoe
should be 1/4" to 1/2" below the cutting edge.
For hard surfaces (concrete or asphalt): The
bottom surface of the shoe should be even with the
cutting edge.
1. Raise the blade 1 foot off the road surface, turn
the control OFF, and from in front of the blade,
place stand assembly or sturdy blocking under the
cutting edge.
2. Turn the control ON and lower the blade onto the
stand assembly or blocking. Turn the control and
vehicle ignition OFF.
3. Remove the linchpin, and slide the disc shoe down
and out of the shoe holder.
4. Remove one or more washers from the shoe
stem, and reinstall the shoe into the shoe holder.
5. Place the removed washers onto the shoe stem
above the shoe holder.
Shoe Holder
Linchpin
21
WARNING
Washers
Spacer
Disc Shoe
May 1, 2021
Advertisement
Table of Contents
