Table of Contents
Advertisement
6. Troubleshooting
The following guide lists the most common problems that may be encountered when operating this
bar code printer. If the printer still does not function after all suggested solutions have been
invoked, please contact the Customer Service Department of your purchased reseller or distributor
for assistance.
6.1 LED Status
This section lists the common problems that according to the LED status and other problems you may
encounter when operating the printer. Also, it provides solutions.
LED Status /
Printer Status
Color
OFF
No response
Solid Green
Green with
blinking
Red with
blinking
Note:
Printer status can be easily shown on the Diagnostic Tool. For more information about the
Diagnostic Tool, please refer to the instruction in the software CD disk.
Possible Cause
No power
ON
The printer is ready to
use
Pause
The printer is paused * Press the FEED button to resume for printing.
Error
The out of label or the
printer setting is not
correct
Recovery Procedure
* Turn on the power switch.
* Check if the green LED is lit on power supply. If
it is not lit on, power supply is broken.
* Check both power connections from the power
cord to the power supply and from the power
supply to the printer power jack if they are
connected securely.
* No action necessary.
1. Out of label
* Load a roll of label and follow the instructions in
loading the media then press the FEED button
to resume for printing.
2. Printer setting is not correct
* Initialize the printer by instructions in "Power on
Utility" or "Diagnostic Tool".
- 35 -
Advertisement
Table of Contents
