Printer Initialization - Wasp WPL206 Series User Manual

4.3 Printer Initialization

Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns green after 5 amber blinks. (Any green will do during the 5 blinks).
The LED color will be changed as following:

Amber  red (5 blinks)  amber (5 blinks)  green (5 blinks)  green/amber (5 blinks)  red/amber
(5 blinks)  solid green
Printer configuration will be restored to defaults as below after initialization.
Parameter
Speed
Density
Media Width
Media Height
Sensor Type
Print Direction
Reference Point
Gap Offset
Post-Print Action
Serial Port Settings
Code Page
Country Code
Clear Flash Memory
Note:
When printer initialization has done, please calibrate the gap or black mark sensor before printing.
Default setting
127 mm/sec (5 ips) (203DPI)
76.2 mm/sec (3 ips) (300 DPI)
8
4" (101.5 mm)
4" (101.5 mm)
Gap sensor
0
0,0 (upper left corner)
0
Tear mode
9600 bps, none parity, 8 data bits, 1 stop bit
850
001
No
- 25 -