Installation Related - EchoStar DVR-5000 HDD User Manual

Troubleshooting
Section 7

1.6. INSTALLATION RELATED

Problem
1. My television does not
receive any signal from
the receiver (UHF only)
2. My television does not
receive any signal from
the receiver
3. My television shows black
areas on the left and right
of the screen.
4. In a DiSeqC1.2 moveable
dish installation, I cannot
select a specific satellite.
5. In a DiSeqC1.2 moveable
dish installation, the
DiSeqC1.2 motor reacts
unpredictable which
results in incorrect
positioning of the dish.
6. During (initial) setup of
the receiver, no channels
are found.
Page 7 - 4
Possible cause
You did not select the
correct audio/video
channel on your TV.
You did not select the
correct A/V channel on
your TV.
You did not use a correct
SCART cable.
You did not select the
correct aspect ratio for
your TV.
The required satellite is
located outside the
selected East or West
limit.
The cables used are
worn, damaged or
corroded.
The cable is incorrectly
finished or not sufficiently
shielded.
You did not select the
correct LNB(F).
When installed, you have
selected the incorrect
switch type or port.
You have selected the
incorrect satellite to
search channels on.
You have selected the
incorrect search method.
What to do?
Refer to the user manual
of the TV for instructions.
On the receiver, In the TV
system menu select the
correct channel and PAL
setting.
Use another method to
connect the receiver.
Select the correct A/V
channel on your TV.
Use only a full featured
SCART cable that is
correctly shielded.
On the receiver, in the
user profile menu select
the correct aspect ratio.
If physically possible,
mind dish damage, revise
the limit setting.
Select another satellite.
Inspect the cable for
possible damage and
install new cable as
required.
Use sufficiently shielded
and correctly finished
cables.
On the receiver, in the
installation setup menu
select the correct LNB(F).
On the receiver, in the
installation setup menu
make the correct
selections.
On the receiver, in the
installation setup menu
select the correct
satellite.
At an initial setup, always
choose the option All.
EchoStar DVR-5000