Installation Related - EchoStar DSB-2200 2Ci User Manual

1.4. REMOTE CONTROL UNIT (RCU) RELATED
Problem
1. Receiver does not
respond to the RCU.
2. Receiver does some-
times not respond to the
RCU.

1.5. INSTALLATION RELATED

Problem
1. My television does not
receive any signal from
the receiver (UHF only)
2. My television does not
receive any signal from
the receiver
3. My television shows black
areas on the left and right
of the screen.
4. During (initial) setup of
the receiver, no channels
are found.
Digital Satellite Receiver
Possible cause
Batteries are empty.
Direct sun light from
behind the receiver.
You do not aim
sufficiently at the receiver.
Batteries are almost
empty.
Possible cause
You did not select the
correct audio/video
channel on your TV.
You did not select the
correct A/V channel on
your TV.
You did not use a correct
SCART cable.
You did not select the
correct aspect ratio for
your TV.
You did not select the
correct LNB(F).
When installed, you have
selected the incorrect
switch type or port.
You have selected the
incorrect satellite to
search channels on.
You have selected the
incorrect search method.
Troubleshooting
What to do?
Insert new batteries.
Close the sun blinds or
get closer to the receiver.
Aim at the receiver
display.
install a RCU extender.
Insert new batteries.
What to do?
Refer to the user manual
of the TV for instructions.
On the receiver, In the TV
system menu select the
correct channel and PAL
setting.
Use another method to
connect the receiver.
Select the correct A/V
channel on your TV.
Use only a full featured
SCART cable that is
correctly shielded.
On the receiver, in the
user profile menu select
the correct aspect ratio.
On the receiver, in the
installation setup menu
select the correct LNB(F).
On the receiver, in the
installation setup menu
make the correct
selections.
On the receiver, in the
installation setup menu
select the correct
satellite.
At an initial setup, always
choose the option All.
Section 7
7
Page 7 - 3