Special Functions - EchoStar DVR-5000 HDD User Manual

EchoStar Quattro, Programmable Remote Control Unit
5.1. SETUP A SECOND TV OR VCR
NOTE
The procedure to assign a second TV or VCR is identical, therefor only the
procedure to assign the second TV is given.
1. On the RCU, press the TV key continuously until the indicator stays on.
2. Release the TV key and make sure the indicator blinks continuously.
3. Use the numerical keys to enter code 9 9 2.
4. Monitor the TV key and note that the indicator goes on and off and finally stays on.
5. Press the VCR key once and note that the indicator goes on and off and finally stays off.
6. Now the VCR key is assigned as a TV key.
7. Setup the VCR key to control your second TV, refer to chapter 4 for detailed instructions.
5.2. UNDO THE SETUP OF A SECOND TV OR VCR
NOTE
The procedure to undo an assignment for the TV or VCR is identical, therefor only
the procedure to undo the assignment of the VCR key as a second TV is given.
1. On the RCU, press the VCR key continuously until the indicator stays on.
2. Release the VCR key and make sure the indicator blinks continuously.
3. Use the numerical keys to enter code 9 9 2.
4. Monitor the VCR key and note that the indicator goes on and off and finally stays on.
5. Press the VCR key once and note that the indicator goes on and off and finally stays off.
6. Now the VCR key is assigned as a VCR key.
7. Setup the VCR key to control your VCR, refer to chapter 4 for detailed instructions.
6.

SPECIAL FUNCTIONS

6.1. VOLUME LOCK (PUNCH THROUGH)
The RCU allows you to select the device that you want to control the volume of,
independently from any other mode. As an example, if you are in the SAT mode, you can stay
in the SAT mode and adjust the volume of the TV directly with the volume +/- key.
NOTE
The procedures to set the volume lock for the TV, VCR, DVD and Audio equipment
is identical, therefor only the procedure to set the volume lock for the TV is given.
1. On the RCU, press the TV key continuously until the indicator stays on.
2. Release the TV key and make sure the indicator blinks continuously.
3. Use the numerical keys to enter code 9 9 3.
4. Press the TV key once.
5. Monitor the TV key and note that the indicator blinks three times.
6. Now the volume control is locked to the TV except for the AUX mode.
6.2. RESET VOLUME LOCK (PUNCH THROUGH)
1. On the RCU, press the SAT key continuously until the indicator stays on.
2. Release the SAT key and make sure the indicator blinks continuously.
3. Use the numerical keys to enter code 9 9 3.
4. Press the Volume + key once and note that the indicator blinks four times.
5. Now the volume control is unlocked to control the device that belongs to that key.
Digital Satellite Receiver
Appendix 2
A2
Page A2 - 5