EchoStar DSB-2200 2Ci Viaccess User Manual page 55

F
OR CONDITIONAL ACCESS
Problem
1. No picture or sound in the
TV or radio mode.
2. Bad picture or noisy
sound in the TV or radio
mode.
3. The TV shows a
No Signal message.
4. There is no Dolby digital
(AC-3) sound to my other
equipment.
5. I cannot view or listen to a
scrambled channel.
6. I cannot find a channel
which should be there.
7. The TV shows a popup:
EchoNAV User Interface
Possible cause
I
Receiver is in standby.
I
Cable related problems.
I
Dish/LNB related
problems.
I
Bad reception of the
signal.
I
Signal interference with
UHF-installation.
I
Bad reception of the
signal.
I
The equipment is
connected to the receiver
with a RCA or SCART-
cable only.
I
The CI-module/smart card
is not valid.
I
The CI-module/smart card
is not (correctly) inserted.
I
The group or sort option is
set.
I
You are in the wrong list.
I
The channel is hidden.
I
You have selected an
empty (favorite) list.
Troubleshooting
What to do?
I
Switch the receiver on.
I
Check the cable
connections and do any
necessary work.
I
Make sure the dish and
LNB are correctly
adjusted. Do any
necessary work.
I
Make sure the dish and
LNB are clean and
correctly adjusted. Do any
necessary work.
I
Check the UHF settings.
Make sure you use the
correct channel. Please
refer to the TV/radio user
guide.
I
Make sure the channel
selected transmits.
I
Make sure the correct
dish or LNB is selected.
I
Make sure the dish and
LNB are clean and
correctly adjusted. Do any
necessary work.
I
Connect the
S/P DIF connector of the
receiver to the Dolby
digital input of the
receiving equipment.
I
Insert, for this service, a
valid CI-module/smart
card.
I
Insert the CI-module/
smart card correctly.
I
Set the group and sort
mode to none.
I
Check the all channels list
and select the correct
(favorite) list.
I
Unhide the channel.
I
Press the WHITE key
Select the add option.
I
Press the GREEN key
Select the Current Sat or
All Channels list.
Section 7
7
Page 7 - 3