Table of Contents
Advertisement
5) Attach the washer (XD1-1106-235) [3] between the E-ring [1] and the bushing [2] of the lower delivery roller
However, if the lower delivery roller is a new type, attaching the washer (XD1-1106-235) [3] is not required.
6) While attaching the bushing on the rear side of the lower delivery roller, attach the supporting plate [1] which was removed in
the step 3).
- Screw [2] 1 pcs
7) Loosen the 2 screws [1], rotate the gear [2] in an arrow direction with a hand, pull out the front/rear tray auxiliary guide [3] for
approx. 10 mm, and then tighten the 2 screws [1].
8) Assemble the parts by reversing the step 1).
9) Select the motor to check operation.
Service Mode (Level1) SORTER > FUNCTION > MTR-CHK enter "17" and press "OK".
[Reference] After "17" is entered, the tray auxiliary guide motor (M109) is selected.
10) Service Mode (Level1) SORTER > FUNCTION > MTR-ON press "OK" to drive the tray auxiliary guide motor (M109) and
check the operation of the tray auxiliary guide.
[Service parts]
No.
1
Old
FM1-H272-000
New
FM1-H272-010
2
Old
New
XD2-1100-505
[Countermeasure cut-in serial number in factory]
Model
Staple Finisher Y1
Booklet Finisher Y1
Part Number
ROLLER, DELIVERY,LOWER
ROLLER, DELIVERY,LOWER
RETAINING RING (E-TYPE)
Description
Serial number
WEU02657
WEY00839
42
Q'ty
Fig.No.
1->0
L20
0->1
L20
0->1
Advertisement
Table of Contents
