Table of Contents
Advertisement
b-2) Enter -50 in the section for entering the adjusted value [a] of the target paper and press OK [b] (the image below is the case
of A4)
[Note] This operation stops the alignment plate at the alignment position +5.0mm.
b-3) Set one sheet of paper [1] in the processing tray unit, fit it to the edge [b] of the rear alignment plate [2], and then measure
the gap [a] between the edge of the front alignment plate [3] and the paper with a scale.
[Note] Since the alignment plate is installed a bit tilting toward the delivery direction, set the paper to be fitted to the edge (on the
delivery side).
b-4) Enter the gap value measured in the above step b-3) in the calculation formula below, enter the calculated adjusted value
[a] and press OK [b].
Adjusted value = gap (mm) x 10 - 50
[Note] Correspondence table of measured gap value and adjusted value.
Gap mm ( measured value )
Adjusted value
2.0
2.5
3.0
3.5
4.0
4.5
5.0
8
- 30
- 25
- 20
- 15
- 10
- 5
0
Advertisement
Table of Contents
