Hdd Unit; Handle The Hdd Units; Hdd Unit Holding Bracket - Panasonic WJ-NX400K/G Important Information Manual

HDD unit

Handle the HDD units

To install a hard disk drive in the recorder, it is necessary to assemble an HDD unit (encase the hard disk drive in the HDD canister).
The HDD unit is designed to easily install/remove the hard disk drive in/from the recorder.
Contact your dealer about purchasing, installing, and replacing the hard disk drives.
Important:
• The HDD unit is a precision device. Handle them with care. Vibration and shocks may cause failure of the HDD unit.
• Before transportation, read "HDD unit holding bracket" (this page) and "When you transport the recorder" (☞ Page 22).
• Do not move or install this product just after turning the power on or off (for around 30 seconds.) The hard disk drives are
running.
• Install the HDD units in order starting with disk slot 1.
• Once the operation has started in RAID1*, RAID5* or RAID6* mode, do not change the position of the HDD unit. If they are
changed, it may become impossible to read recorded data.
* Refer to Operation/Settings of the Operating Instructions for RAID mode.

HDD unit holding bracket

The recorder has the "HDD unit holding bracket" in the HDD unit slot, screwed in at the factory before shipment. To install the
HDD unit in the recorder, remove the "HDD unit holding bracket" first.
The "HDD unit holding bracket" and the screw for fixing the bracket are necessary to prevent the HDD unit from falling off during
transportation. Keep them properly.
How to remove the HDD unit holding bracket
② Slide the HDD unit holding
bracket to the right and
remove it.
HDD unit holding bracket
②
①
① Remove the fixing screw for bracket.
21