Motor Specifications And Electrical Requirements - Skil 3600 Operating/Safety Instructions Manual

motor Specifications and electrical Requirements

General Specifications
Voltage Rating . . . . . . . . . . . . . . . . . . .120 V, 60 Hz
Amperage Rating . . . . . . . . . . . . . . . . . . . . . . . .7 A
No Load Speed . . . . . . . . . . . . . . . . . .n
Table size . . . . . . . . . . . . . . . . . . . . . . .27" x 17-3/4"
Double insulated Tools
Double Insulation is a design concept used in electric
power tools which eliminates the need for the three wire
grounded power cord and grounded power supply system. It is
a recognized and approved system by Underwriter's Lab-
oratories, CSA and Federal OSHA authorities.
impoRTANT: Servicing of a tool with double insulation re-
quires care and knowledge of the system and should be
performed only by a qualified service technician.
WHEN SERVICING, USE ONLY IDENTICAL REPLACE-
MENT PARTS.
POLARIZED PLUGS. To reduce the risk of electric shock,
your tool is equipped with a polarized plug (one blade is wider
than the other), this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to install the
proper outlet. To reduce the risk of electric shock, do not
change the plug in any way.
Replace damaged cords immediately. Use of damaged
cords can shock, burn or electrocute.
Always use proper extension cord. If an extension cord is
necessary, a cord with adequate size conductors should be
11,000/min
used to prevent excessive voltage drop, loss of power or over-
o
heating. The table shows the correct size to use, depending
on cord length and nameplate amperage rating of tool. If in
doubt, use the next heavier gauge. Always use U.L. and CSA
listed extension cords.
"SAVe TheSe iNSTRUcTioNS"
7.
extension cords
RecommeNDeD SiZeS of eXTeNSioN coRDS
120 VolT AlTeRNATiNG cURReNT ToolS
cord Size in A.W.G.
Tool's
Ampere
cord length in feet
Rating
25 50 100 150
3-6
18 16 16
6-8
18 16 14
8-10
18 16 14
10-12
16 16 14
12-16
14 12 —
NoTe: The smaller the gauge number, the heavier the cord.
Wire Sizes in mm
cord length in meters
15 30 60 120
14 .75 .75 1.5 2.5
12 .75 1.0 2.5 4.0
12 .75 1.0 2.5 4.0
12 1.0 2.5 4.0 —
— — — — —
2