Panasonic EP-MA100 Operating Instructions Manual page 91

Question
Other
The controller holder is unsteady .
The displays of the operation or
position seem to be different ...
The noise grows louder after
using the chair for a long time .
Is there a timer function?
Does the time vary depending on
the course?
Can I change time settings myself?
What should I do if the massage
lounger is powered off?
Tighten the controller holder fixing screw .
The holder is held tighter by turning the mounting screw in the direction of
• Controller unit holder cannot be completely secured in order to allow
adjustment to desired positions and orientations.
The actions shown represent rough movements .
Actual movements or sensations may vary .
This may be a malfunction . Contact the nearest authorized service
center for an inspection and repair .
Yes .
To prevent overuse, the massage automatically ends at a maximum of
19 minutes after starting. (EN28)
When the timer ends, the legrest automatically lowers and the massage
rollers are stowed.
Press to use again.
The time setting of the timer
function changes depending on
the course . (EN28)
That is not possible .
The set time is predetermined for
each course.
Please refer to SC11 to confirm first .
① If the power supply in your home is normal, you can try another
power supply to connect the massage lounger .
② Is the power cord of your massage lounger loose?
③ Is the switch on the power control box of your massage lounger
in the "开" position?
④ Is your massage lounger lock switch key connected properly
and in the "锁定" position?
Note: If the massage lounger cannot be started after the above
steps are confirmed, please call the After-sales Service Hotline .
Answer
Controller holder
Controller holder fixing screw
Swedish
Deep
Shiatsu
Stretch
Air
Quick
About 19 minutes
.
about 19 minutes
about 16 minutes
about 10 minutes
EN43