Table of Contents
Advertisement
DUST BAG
The dust bag (A) Fig.6 fits into the dust bag adaptor (B) at the rear of the saw
head. For more efficient operation, empty the dust bag when it is no more than
half full. This allows better air flow through the bag.
BENCH MOUNTING
The saw base has holes to facilitate bench mounting.
1. Fix the saw to a bench using 4 hex. bolts and hex. nuts.
2. If desired, you can mount the saw to a piece of 13mm or thicker plywood which
can then be clamped to your work support or moved to other job sites and
reclamped.
CAUTION: Make sure that the mounting surface is not warped as an uneven
surface can cause binding and inaccurate sawing.
ADJUSTING FENCE EXTENSIONS
This miter saw comes with a back fence with fence extensions (A) Fig.7 at both
ends which slide outwards for additional back support for those long workpieces.
Please note that during steep bevel cut operations, these fence extensions must
be fully extended to not interfere with the motor housing or blade guard. To adjust
the position of each fence extension:
1. Loosen the fence extension lock knob (B) Fig.7.
2. Slide the fence extension outwards to the desired position and retighten the
rear lock knob.
DEPTH OF CUT STOP ADJUSTMENT
In its normal position, the depth of cut stop (A) Fig.8 permits the saw blade to cut
right through a workpiece. When the saw arm is lifted, the depth of cut stop (A)
Fig.9 can be slid over towards the right so that the depth adjustment screw (B)
contacts the stop as the saw arm is lowered. This restricts the cut to a "adjusted
depth" in the workpiece. The depth of cut can be adjusted with the adjustment
screw and locked in position with the lock nut (C) Fig.9.
ADJUSTING BEVEL ANGLE
This miter saw is capable of dual bevel angles which means the saw head can
be inclined or tilted towards the right or the left. To adjust the saw head to any
bevel angle:
Loosen the bevel lock knob (A) Fig.10 and pull the positive stop adjustment knob
(B) outwards as shown. At this point, the saw head can be inclined to any angle
you desire. If you require a predetermined bevel angle of 0
knob inwards and pivot the saw head until it stops at 0
angle is obtained, it is very important that you retighten the bevel lock knob (A).
ADJUSTMENTS
0
, push the adjustment
. Once the desired bevel
0
FIGURE 10
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9
Advertisement
Table of Contents
