12. Power Take-Off (If equipped) —
Follow the manufacturer's recom-
mendations covering the return of
the power take-off to service.
13. Turbocharger—Remove the cov-
ers from the turbocharger air inlet
and turbine outlet connections.
Reconnect piping as required.
Prelube the turbocharger. Refer to
the lubricating procedure outlined in
Preparations for Starting the
Engine the First Time (page 3).
14. After all preparations are completed,
start the engine. The small amount
of rust preventive compound which
remains in the fuel system will cause
smoky exhaust for a few minutes.
NOTE:
Before subjecting the engine to a load
or high speed, allow it to reach normal
operating temperature. Then, monitor
the DDEC Diagnostic Data Link for trou-
ble codes.
71