Installation Instructions - Kenmore 31510 Use & Care Manual

1. Remove Protective Covers and
Film
Before using robot, remove the protective
covers and film on the robot and charging
dock.
2. Set-Up the Charging Dock
Position the charging dock on a level
surface against the wall in a location that
can be easily accessed by the robot. Be
sure to remove all objects that are closer
than 5ft (1.5m) from the front and 3ft (1m)
from either side of the dock.
NOTE:
It's recommended to add a piece
of double sided tape to the bottom of the
dock to keep it from sliding.
3. Connect the Charging Adapter
Plug the charging adapter into a wall outlet
and plug the connector into the socket on
the side of the charging dock. When the
charging dock connects to a power supply,
the LED indicator on the charging dock will
flash. The charging dock must be plugged
in at all times for the robot to find the
dock.

INSTALLATION INSTRUCTIONS

4. Install Side Brushes
The robot comes with two side brushes that
need to be installed on the bottom of the
vacuum. Each side brush is installed on a
specific side of the robot and indicated
with an L or R. Match up the letter on the
side brush with the letter on the back of
the robot. To install, simply push side brush
onto the square peg until a "snap" can be
heard.
5. Charge the Robot
The robot has a pre-installed rechargeable
battery, which must be charged before
using. There are 3 options for charging,
which include manually placing robot
on the charging dock, pressing the
button on the robot, or using the APP.
Option 1 – Manually Connect Robot to
Charging Dock
Align the charging pins on the bottom
of the robot with the charging pins on
the dock. When the robot is successfully
connected to the charging dock, an
audible tone will activate. The docking
indicator light on the robot will flash
to indicate the robot is charging. Once
charging is completed, the indicator light
will illuminate steadily. Charging time is
approximately 3.5 hours.
- 11 -