3.1.3
When to Use the SCSISelect Utility
Use the SCSISelect utility if you need to
Change any of the default values listed in the settings table
Check and/or change SCSI device settings that may conflict with those of
other devices (e.g., SCSI ID)
Perform low-level formatting on new SCSI disk devices
3.1.4
Running the SCSISelect Utility
To start SCSISelect, press Ctrl+A when the following is displayed during power-up
or reset:
Press <Ctrl> <A> for SCSISelect
This message appears after BIOS and POST information displays, and after the
banner listing the Adaptec AHA-3950U2B version number.
Utility!
Chapter 3 – SCSISelect Configuration Utility 3-3