Table of Contents
Advertisement
2.6
Power Management
The
Power
Management
power-management feature.
The following screen shows the Power Management parameters and their default
settings:
Power Management Mode ................. [Disabled]
IDE Hard Disk Standby Timer ......... [Off]
System Sleep Timer .................. [Off]
Sleep Mode ........................ [----]
Power Switch < 4 sec. . ............... [Power Off]
System Wake-up Event
Modem Ring Indicator ................ [Disabled]
2.6.1
Power Management Mode
This parameter allows you to reduce power consumption. When this parameter is
set to Enabled, you can configure the IDE hard disk and system timers. Setting it
to Disabled deactivates the power-management feature and its timers. The default
setting is Disabled.
IDE Hard Disk Standby Timer
This parameter allows the hard disk to enter standby mode after inactivity of 1 to
15 minutes, depending on your setting. When you access the hard disk again,
allow 3 to 5 seconds (depending on the hard disk) for the disk to return to normal
speed. Set this parameter to OFF if your hard disk does not support this function.
menu
Power Management
Make sure that Power Management Mode is
Disabled at all times.
allows
you
to
configure
the
Chapter 2 - BIOS Utility 2-21
system
Advertisement
Table of Contents
