Table of Contents
Advertisement
For the password to take effect you must set jumper JP3 to 1-2 (Check password):
1.
Turn off and unplug the computer.
2.
Open the computer housing and set JP3 to 2-3 (Bypass password) to bypass the
password function. See figure 1-2 for the location of JP3.
3.
Close your computer's housing and reboot your system.
The next time you want to enter the BIOS utility, you must key in your Setup
password.
To remove your Setup Password:
1.
Disabled the Setup Password parameter in the System Security menu by
pressing the
2.
Press
to return to the System Security menu and then press
exit Setup. The Exit Setup screen appears:
Settings have been changed.
Do you want to save to CMOS settings?
3.
Press Yes to save your settings and exit Setup Utility.
password will be removed from CMOS.
or
arrow key to select None.
Exit Setup
[Yes]
[No]
Remember to set JP3 to 2-3 (Bypass
password) because you won't be able to
access Setup Utility if a password does not
exist and JP3 is set to 1-2 (Check password).
Your
Chapter 2 - BIOS Utility 2-37
again to
previous
Advertisement
Table of Contents
