Activation And Wireless Alarm Network; Setting Up A Wireless Alarm Network - Kidde P4010ACS-W User Manual

9. Activation and Wireless Alarm Network

Upon initial power being applied (from rotating onto mounting plate or moving the red activation wheel to the "ON"
position - see Figure 9.1-B) these units are ready to connect to a network.
note:
At any time during wireless alarm setup, if you have a problem, you can push and hold the Test/Hush
button on any problem unit until you hear three (3) beeps (approx 8 sec), and then release the button. The unit will
reset the unit's wireless settings (described in Section 9.3). Once wireless settings are reset, the unit will prompt the
user to follow Quickstart instructions.

9.1 Setting Up a Wireless Alarm Network

Creating an interconnected wireless alarm network is a simple process, with intelligent "self-enrollment" features, and
user-friendly voice prompts.
A. reMoVe All deVIceS FroM tHeIr pAckAgIng
b. poWer Up All deVIceS
•
Locate the red wheel on the back of the device. Turn the red wheel to
the "ON" position on ALL devices using the white tool included with the
Quick Start Guide.
•
Once powered, the light rings will glow red and voice message will
announce,
"Ready to connect. Follow Quick Start instructions."
ACTIVATION
TOOL
Figure 9.1-B
13