Installation For Use; Preparation Of Mower - Cub Cadet 59A30044150 Operator's Manual

Section II - INSTALLATION FOR USE

2-1 Preparation Of Mower

NOTE: The mower deck PTO belt must be removed
from the electric clutch before continuing with the
installation. Refer to your Cub Cadet mower owner's
manual for instructions on PTO belt removal.
From the underside of the engine, disconnect the wiring
harness attached to the electric clutch. Remove the bolt
and electric clutch from the mower. Remove the D-drive
spacer using an arbor press or equivalent. On removal,
adjacent bearing OUTER race must be supported or
bearing damage may occur. Refer to Figure 2-1a.
Figure 2-1a
The engine pulley assembly must be installed using an
arbor press or equivalent. During installation, opposite
bearing inner race must be supported or bearing
damage may occur. Refer to Figure 2-1c.
Figure 2-1c
Engine Pulley Bushing Installation
Once the Engine Pulley Bushing P#(S0210) is installed,
reattach the clutch assembly to the mower and then
review Figure 2-1c.
6
PRESS
PRESS
Figure 2-1c
Pulley
Bushing
Number
Located
Here
Lock Washer
To assemble and fasten the Engine Pulley, align Pulley
hole to the Engine Pulley Bushing and fasten using (1)
Clamp Washer P#(K0278), (1) 7/16"-20 x 3-3/4" HHCS
P#(K0350) and (1) 7/16" helical spring lock washer
P#(K0140). Torque the bolt to 55ft./lbs. Refer to
Figure 2-1d for reference.
Figure 2-1d
Engine Pulley Assembled Into Electric Clutch
NOTE: Replace the mower deck PTO belt removed at
the beginning of this section.
Remove the rear bumper and hardware from the mower
as shown in Figure 2-1e.
Figure 2-1e
Remove
Rear Bumper
Engine Pulley
Bushing
Pulley
Clamp Washer
Hex Bolt
Electric Clutch