Panasonic SFC-HC Instruction Manual page 6

Handy controller exclusive for sf4c series

Table of Contents

INTRODUCTION

)L[HG EODQNLQJ IXQFWLRQ ÀRDWLQJ EODQNLQJ IXQFWLRQ

:LWK WKH ¿[HG EODQNLQJ IXQFWLRQ WKLV GHYLFH SUHYHQWV WKH SHUVRQ RU REMHFW IURP HQWHULQJ LQWR

the dangerous parts of the machine through the invalid sensing area. However, even though

this device can prevent the interference of the person or object into the invalid sensing area

ZLWK WKH ¿[HG EODQNLQJ IXQFWLRQ WKHUH PLJKW H[LVW WKH PRUH VSDFH EHWZHHQ WKH SF4C series

and already-existence object. Therefore, set the protecting structure so as not to exist any

space in the dangerous sensing area. Detecting human body in the sensing area could re-

sult in death or serious injury.

:LWK WKH ÀRDWLQJ EODQNLQJ IXQFWLRQ WKLV GHYLFH FKDQJHV WKH VL]H RI WKH PLQLPXP VHQVLQJ RE-

ject of the SF4C series that is pre-set the function. When setting or changing the function,

calculate and measure the safety distance again, and check that the device has the wider

space than the safety distance between the dangerous parts of the machine and the sensing

area of the SF4C series. ,I WKH VXI¿FLHQW GLVWDQFH LV QRW PDLQWDLQHG WKH PDFKLQH ZLOO QRW VWRS

before its dangerous parts are reached, which can result in death or serious injury.

Set and change the function of the device following the relative laws, regulation, and stan-

dard without fail.

Muting setting changing function

The muting setting changing function temporarily invalidates safety function of the connected

GHYLFHV &RQ¿UP DOO RI WKH DSSOLHG ODZV DQG VWDQGDUGV DQG LQVWDOO RU RSHUDWH WKLV GHYLFH DQG

peripheral devices correctly. Failure to do so, the operator may suffer a serious injury.

Environment

Do not use a mobile phone or a radio phone near this device.

Do not use this device in the following environments.

1) Areas with high humidity where condensation is likely to occur

2) Areas exposed to corrosive or explosive gases

3) Areas exposed to vibration or shock of high levels

4) Areas exposed to contact with water

5) Areas exposed to too much steam or dust

Wiring

Be sure to carry out the wiring in the power supply OFF condition.

All electrical wiring should conform to the regional electrical regulations and laws. The wiring

should be done by engineer(s) having the special electrical knowledge.

Do not run the wires together with high-voltage lines or power lines or put them in the same

raceway. This can cause malfunction due to induction.

Maintenance

Clean this device with a clean cloth. Do not use any volatile chemicals.

Other

Never reassemble or remodel this device.

Table of Contents