Panasonic SFC-HC Instruction Manual page 9

Handy controller exclusive for sf4c series

Table of Contents

Wire a discrete connection cable with connector on one end SFC-WNC1 (optional) to this device.

And wire a clip of the discrete connection cable with connector on one end to a lead wire of cable

type of SF4C series.

It is also possible to use in condition that an intermediate connector type of SF4C series is wired

to a cable with connector on one end 6)%&& 08 (optional).

Emitter

Connection cable with a

connector on one end

This device

Connection cable with a connector on one end: 1 pc./set

Model No.

Cable length

SFC-WNC1

‡ The setting procedure remains the same.

‡ The control output (OSSD 1 / 2) of SF4C series is set to "OFF" while this device has been con-

nected. Once the setting is completed, turn OFF the power, remove this device and then turn ON

the power again.

Receiver

24V±10%

Cable which incorporates clips on end of the discrete wire.

When the lead wire contacts with other lead wires, maximally 26.4V DC of voltage is ap-

SOLHG DQG $ RI FXUUHQW ÀRZV

In case the connecting cable with connector on one end connected the cable type of

SF4C series or the intermediate connector type to this device, lead wire may be discon-

nected. Be sure the lead wire is not disconnected.

Connecting / Setting Procedures