Programming; Extra Features (Sync) - Metra Electronics 99-5838CH Installation Instructions Manual

PROGRAMMING

1. Refer to step 2 from the Installation section.
2. Press the push-to-start button to start the vehicle.
Note: If the Push-to-Start module in the center console has been disconnected, reconnect it.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type.
b. Wait until the radio comes on, and the touchscreen display shows SWC Configured.
This process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn't come on within
3 minutes, and/or the touchscreen display does not show SWC Configured, check all
connections, then reset the interface and try again. Refer to the Troubleshooting section.
4. Cycle the key off. If the driver's door is closed, open and close the door. Cycle the key back on.
5. Test all functions of the installation for proper operation, before reassembling the dash.
FINAL ASSEMBLY
1. Connect the USB cable attached to the radio trim panel with touchscreen display, to the
USB port in the back of the radio, if applicable.
2. Secure the completed assembly into the upper dash using the factory hardware removed in
step 12 of dash disassembly.
3. Snap the radio trim panel with touchscreen display over the completed assembly, and then
reassemble the dash in reverse order of disassembly.
EXTRA FEATURES
SYNC:
If the vehicle is equipped with SYNC, the 99-5838CH can retain this feature.
1. Change the source of the radio to AUX-IN.
2. Press the Info button on the touchscreen display to enter the SYNC menu.
3. Press the climate control icon to get back to the main menu.
REV. 10/28/2020 INST99-5838CH
13