Advertisement
INSTALLATION
With the ignition switch in the off position, connect the:
1. SWC harness to the SWC interface, then to the 9615 interface.
2. 9615 harness to the 9615 interface, then to the wiring harness in the vehicle.
3. USB harness to the radio, then to the wiring harness in the vehicle.
4. Locate the factory antenna connector in the dash and complete all necessary connections
to the radio. Use the antenna adapter provided to adapt the factory antenna to the
aftermarket radio.
6
PROGRAMMING
1. Open the driver's door and keep open during the programming process.
2. Press and hold the Volume Up button on the steering wheel. For models with a scroll wheel,
scroll up quickly.
3. Cycle the ignition switch on.
4. The LED in the SWC interface will quickly flash Green and Red. (a)
5. The LED will go out, then flash Green while the interface programs itself to the vehicle. (b)
6. The LED will go out again, then flash Red up to 22 times while the interface programs itself
to the radio. (c)
7. Once programmed, the LED will go out briefly, then turn solid Red. (d)
8. Release from holding the Volume Up button. Test all functions of the installation for
proper operation. (e)
(a) If the LED doesn't flash, press the reset button for 3 seconds to reset the interface.
(b) There will be a series of 7 Green flashes, some short, some long. The long flashes
represent the wires connected to the interface. The 3rd, 4th, 5th, and 6th flashes
should be longer.
(c) The number of flashes identify the radio installed. Refer to the AXSWC Radio
Troubleshooting document available from axxessinterfaces.com for more information.
(d) If the LED didn't turn solid Red, press the reset button for 3 seconds to start the process
over again, then resume from step 3.
(e) Refer to the AXSWC documents available from axxessinterfaces.com for customizing
the SWC buttons.
Continue to Final Assembly
|
386.257.1187
MetraOnline.com
Advertisement
