Activating And Deactivating The Alarm System; If You Have Accidentally Triggered The Alarm System; Arming The System - Subaru 2007 Legacy Owner's Manual

Hide thumbs Also See for 2007 Legacy:
Table of Contents

Advertisement

. Opening a door, the rear gate or trunk
lid
. Physical impact to the vehicle, such as
forced entry (only vehicles with shock
sensors (dealer option))
& Activating and deactivating
the alarm system
To change the setting of your vehicle's
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system (see "Dis-
arming the system" in this section).
2. Sit in the driver's seat and shut all
doors (and the rear gate if your vehicle is a
Station wagon).
3. Turn the ignition switch to the "ON"
position.
4. Hold down the UNLOCK side of the
driver's power door locking switch, open
the driver's door within the following 1
second, and wait 10 seconds without
releasing the switch. The setting will then
be changed as follows:
If the system was previously activated:
For non-turbo models, the odometer/trip
meter screen displays "AL oF", and for
turbo models, the multi-information display
shows "Security alarm: OFF" and the horn
sounds twice, indicating that the system is
now deactivated.
If the system was previously deactivated:
For non-turbo models, the odometer/trip
meter screen displays "AL on", and for
turbo models, the multi-information display
shows "Security alarm: ON" and the horn
sounds once, indicating that the system is
now deactivated.
NOTE
You may have the above setting
change done by your SUBARU dealer.
& If you have accidentally trig-
gered the alarm system
! To stop the alarm
Do any of the following operations:
. Insert the key in the door lock of the
driver's door and turn it to the unlock
position.
. Press any button on the remote trans-
mitter.
. Turn the ignition switch to the "ON"
position.
& Arming the system
! To arm the system using remote
transmitter
1. Close all windows and the moonroof (if
so equipped).
Keys and doors
2. Remove the key from the ignition
switch.
3. Open the doors and get out of the
vehicle.
4. Make sure that the engine hood (and
the trunk lid on the Sedan) are locked.
5. Close all doors (and the rear gate on
the Station wagon).
: Press to Arm the system.
: Press to Disarm the system.
– CONTINUED –
2-15

Advertisement

Table of Contents
loading

Table of Contents