Subaru 2006 Legacy Owner's Manual page 44

2. Pull out the seatbelt slowly from the
overhead retractor.
3. After confirming that the webbing is not
twisted, insert the connector (tongue) at-
tached at the webbing end into the buckle
on the right-hand side until a click is heard.
If the belt stops before reaching the buck-
le, return the belt slightly and pull it out
more slowly. If the belt still cannot be un-
locked, let the belt retract slightly after giv-
ing it a strong pull, then pull it out slowly
again.
100735
4. After fastening the seatbelt, make sure
that the " " mark on the connector
(tongue) and the "
le face outwards.
100309
5. Insert the center seatbelt tongue plate
in the center seatbelt buckle marked
"CENTER" on the left-hand side until it
clicks.
200298
" mark on the buck-
6. To make the lap part tight, pull up on
the shoulder belt. And place the lap belt as
Seat, seatbelt and SRS airbags
– CONTINUED –
1-19
100114
100310