Before Checking Or Servicing In The Engine Compartment; When You Do Checking Or Servicing In The Engine Compartment While The Engine Is Running; Engine Hood - Subaru 2006 Legacy Owner's Manual

Hide thumbs Also See for 2006 Legacy:
Table of Contents

Advertisement

11-4
Maintenance and service
Wear adequate eye protection to
guard against getting oil or fluids
in your eyes. If something does
get in your eyes, thoroughly wash
them out with clean water.
Do not tamper with the wiring of
the SRS airbag system or seatbelt
pretensioner system, or attempt
to take its connectors apart, as
that may activate the system or it
can render it inoperative. The wir-
ing and connectors of these sys-
tems are yellow for easy identifi-
cation. NEVER use a circuit tester
for these wiring.
If your SRS airbag or seatbelt pre-
tensioner needs service, consult
your nearest SUBARU dealer.
Before checking or servicing
in the engine compartment
Always stop the engine and set
the parking brake firmly to pre-
vent the vehicle from moving.
Always let the engine cool down.
Engine parts become very hot
when the engine is running and
remain hot for some time after the
engine is stopped.
Do not spill engine oil, engine
coolant, brake fluid or any other
fluid on hot engine components.
This may cause a fire.
Always remove the key from the
ignition switch. When the ignition
switch is in the "ON" position, the
cooling fan may operate suddenly
even when the engine is stopped.
When you do checking or ser-
vicing in the engine compart-
ment while the engine is run-
ning
A running engine can be dangerous.
Keep your fingers, hands, clothing,
hair and tools away from the cooling
fan, belts and any other moving en-
gine parts. Removing rings, watch-
es and ties is advisable.

Engine hood

To open the hood:
1. If the wiper blades are lifted off the
windshield, return them to their original
positions.
2. Pull the hood release knob under the
instrument panel.
B00099

Advertisement

Table of Contents
loading

Table of Contents