Subaru 2006 Legacy Owner's Manual page 373

Hide thumbs Also See for 2006 Legacy:
Table of Contents

Advertisement

11-40
Maintenance and service
Washer fluid level gauge
Remove the washer tank filler cap, then
check the fluid level indicated by the level
gauge (attached to the inside of the cap).
If the level is near the "Low" mark, add flu-
id until it reaches the "Hi" level on the level
gauge or the "Full" mark on the tank.
Use windshield washer fluid. If windshield
washer fluid is unavailable use clean wa-
ter.
In areas where water freezes in winter,
use an anti-freeze type windshield washer
fluid. SUBARU Windshield Washer Fluid
Hi
contains 58.5% methyl alcohol and 41.5%
surfactant, by volume. Its freezing temper-
ature varies according to how much it is di-
Low
luted, as indicated in the following table.
300172
Washer Fluid
Concentration
100%
In order to prevent freezing of washer flu-
id, check the freezing temperatures in the
table above when adjusting the fluid con-
centration to the outside temperature.
If you fill the reservoir tank with a fluid with
a different concentration from the one
used previously, purge the old fluid from
300173
the piping between the reservoir tank and
washer nozzles by operating the washer
for a certain period of time. Otherwise, if
the concentration of the fluid remaining in
the piping is too low for the outside tem-
Freezing
Temperature
30%
10.4°F (–12°C)
50%
–4°F (–20°C)
–49°F (–45°C)
perature, it may freeze and block the noz-
zles.
Adjust the washer fluid concentra-
tion appropriately for the outside
temperature. If the concentration is
inappropriate, sprayed washer fluid
may freeze on the windshield and
obstruct your view, and the fluid
may freeze in the reservoir tank.

Advertisement

Table of Contents
loading

Table of Contents