Subaru 2006 Legacy Owner's Manual page 169

4-10
Climate control
The fan speed is shown by the display.
A/C – Air conditioner button
If the windshield starts to fog when the cli-
mate control system is operated in the
AUTO mode, push the air conditioner but-
ton "A/C" to defog and dehumidify.
When this button is pushed, the air condi-
tioner compressor turns on and the indica-
tor light "A/C" on the display comes on. Af-
ter eliminating the fogging from the wind-
shield, set the system back to the AUTO
mode by pushing the "AUTO" button.
NOTE
The air conditioner compressor does
not operate when the outside air tem-
perature is below 32°F (0°C).
Air flow mode selection button
Select the desired air flow mode by push-
400586
ing the air flow mode selection button. The
selected air flow mode is shown by the
display.
(Ventilation): Air flows through the in-
strument panel outlets.
(Bi-level): Air flows through the instru-
ment panel outlets and the foot outlets.
(Heat): Air flows through the instru-
ment panel outlets, the foot outlets, and
some through the windshield defroster
outlets.
(Heat-def): Air flows through the instru-
ment panel outlets, the windshield defrost-
er outlets, and the foot outlets.
Air inlet selection button
400587
Select air flow by pushing the air inlet se-
lection button "
The selected air inlet setting is shown on
the control panel.
(Recirculation): Interior air recircu-
lates inside the passenger compartment.
Use this position when quickly cooling
down the passenger compartment or to
prevent outside air from entering the pas-
senger compartment. When the recircula-
tion mode is selected, a "
light appears on the display.
(Outside air): Outside air is drawn
into the passenger compartment. When
the climate control system is operated in
the "AUTO" mode, this position is selected
400588
/ ".
" indicator