Disarming The System; Valet Mode - Subaru 2006 Legacy Owner's Manual

2-16
Keys and doors
6. Push the front side ("LOCK" side) of
the power door locking switch to set the
door locks.
7. Close the door. An electronic chirp will
sound once, the turn signal lights will flash
once and the indicator lights will start
flashing rapidly. After rapid flashing for 30
seconds (standby time), the indicator
lights will then flash slowly (twice approxi-
mately every two seconds), indicating that
the system has been armed for surveil-
lance.
NOTE
The system can be armed even if the
engine hood, the windows and/or
moonroofs are opened. Always make
sure that they are fully closed before
arming the system.
The 30-second standby time can be
eliminated if you prefer. Have it per-
formed by your SUBARU dealer.
If your vehicle is a Sedan and you un-
lock the trunk using the remote trans-
mitter's "
system armed, the system will be tem-
porarily placed in a standby state. The
system will go back to the surveillance
state upon locking the trunk.
The system is in the standby mode
for a 30-second period after locking the
200897
doors with the remote transmitter. The
security indicator light will flash at
short intervals during this period.
If any of the following actions is done
during the standby period, the system
will not switch to the surveillance state.
Doors are unlocked using the re-
mote transmitter.
Any door (including the rear gate
of a Station wagon or the trunk of a
Sedan) is opened.
Ignition switch is turned to the
"ON" position.

Disarming the system

Briefly press the "
than two seconds) on the remote transmit-
ter. The driver's door will unlock, an elec-
tronic chirp will sound twice, the turn sig-
nal lights will flash twice and the indicator
" button with the alarm
" button (for less
light will go off.
To unlock all other doors and the rear gate
(Station wagon), briefly press the "
button a second time within 5 seconds.
NOTE
If the interval between the first and sec-
ond presses of the "
unlocking of all of the doors and the
rear gate) is extremely short, the sys-
tem may not respond.
Or the system can be disarmed by the
following method, too.
Insert the key in the door lock of the
driver's door and turn it to the unlock
position.
Emergency disarming
If you cannot disarm the system using the
transmitter (i.e. the transmitter is lost, bro-
ken or the transmitter battery is too weak),
you can disarm the system without using
the transmitter.
The system can be disarmed if you turn
the ignition switch from the "LOCK" to the
"ON" position with a registered key.
Insert the key in the door lock of the driv-
er's door and turn it to the unlock position.

Valet mode

When you choose the valet mode, the
alarm system does not operate. In valet
"
" button (for