Pontiac 2003 Aztek Owner's Manual page 98

Canadian Owners: If you lose or damage your keys,
only a GM dealer can service PASS-Key@ I l l to
have new keys made. To program additional keys you
will need two current driver's keys (black in color).
You must add a step to the following procedure. After
Step 3, repeat Steps 1 through 3 with the second current
driver's key. Then continue with Step 4.
To program the new PK3 key do the following:
1. Verify the new key has PK3 stamped on it.
2. Insert the current driver's key in the ignition and
start the engine. If the engine will not start, see
your dealer for service.
3. After the engine has started, turn the key to OFF,
and rel~1ove the key.
4. Insert the key to be programmed and turn
it to
ON
within 10 seconds of removing the previous key.
5. The SECURITY message will turn off once the key
has been programmed. It may not be apparent that
the SECURITY message went on due to how
quickly the key is programmed.
6. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you are ever driving and the SECURITY message
comes on and stays on, you will be able to restart your
engine if you turn it off. Your PASS-Key@ Ill system,
however, is not working properly and must be serviced
by your dealer. Your vehicle is not protected by the
PASS-Key@ I l l system at this time.
If you lose or damage a PASS-Key@ Ill key, see your
dealer who can service PASS-Key@ Ill to have a
new key made.
2-2 1