Table of Contents
Advertisement
- Immediately after a pre-recording
- Immediately after a recording slot is switched
t The microP2 memory card access LED can be set to constantly off in the main menu → [OTHER FUNCTIONS] → [ACCESS LED]. In this case, turn
off the power before removing the card, or after the card is inserted or after operation (recording, playback, etc.) has stopped, and wait for the charging
to complete before removing the card.
Preventing accidental erasure
To prevent erasing the recorded content of the microP2 memory card by mistake, set the write protect switch of the microP2 memory card to the LOCK
side.
@
NOTE
t Write-protect switch can be switched while the card is being accessed (during recording or playback), but does not take effect until accessing of the
card stops.
microP2 memory card access LED and status of microP2 memory card
microP2 memory card access
LED
Is illuminated green
Is illuminated orange
Flashing orange
Flashing orange rapidly
Flashing green slowly
Off
* Mode check is displayed on the LCD monitor screen or the viewfinder screen. For details, refer to "Screen status display" (page 142).
Recording time of microP2 memory card
r The microP2 memory card that can be used with the camera
This camera can use optional 32 GB and 64 GB microP2 memory card.
@
NOTE
t The driver installed on the camera may be required to be updated depending on the type of microP2 memory card. (page 159)
t Refer to our support desk at the following website for the latest information not included in these operating instructions.
http://pro-av.panasonic.net/
r Recording time of the microP2 memory card
(Example when a 64 GB card is used)
Chapter 3 Preparation — microP2 memory card
microP2 memory card status
Recording possible
Reading/writing are both possible.
Reading/writing are both possible. The card is currently
Recording target
the recording target (including loop recording).
Accessing card
Reading/writing are currently being performed.
The card is being
The microP2 memory card is being recognized.
recognized.
There is no free space on the microP2 memory card.
Card full
Reading only is possible.
The write protect switch on the microP2 memory card is
Write protect
set to the LOCK position. Reading only is possible.
Recording is not possible by the currently set recording
format since the SD memory card, etc. is inserted. To
Unrecordable card
record, change the recording format or use a microP2
memory card.
This card cannot be used on the camera. Replace the
Card not supported
card.
The microP2 memory card is not properly formatted.
Illegal format
Reformat the card.
No microP2 memory card is inserted. The card is waiting
No card
to be recognized.
This microP2 memory card cannot be authenticated.
Select the main menu → [CLIP] → [AUTHENTICATE],
Unauthenticated card
and enter the password.
For details, refer to "Manual CPS authentication"
(page 115).
Write-protect switch
– 39 –
Mode check display*
[ACTIVE]
[ACTIVE]
[ACCESSING]
[INFO READING]
[FULL]
[PROTECTED]
[REC IMPOSSIBLE]
[NOT SUPPORTED]
[FORMAT ERROR]
[NO CARD]
[AUTH NG]
Advertisement
Table of Contents
