Table of Contents
Advertisement
Cautions when setting up the projector
f Install the projector in a place or with a mount that can sufficiently tolerate the weight. The position of the
projected image may shift if the strength is not sufficient.
f Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f The adjustable feet can be removed if not needed in the installation. However, do not use the screw holes
where the adjustable feet were removed to fix the projector to a mount.
Also, do not attach any screws not instructed in the operating instructions of the optional accessories into the
screw holes where the adjustable feet are removed. Doing so may damage the projector.
f When using the projector in any method other than the floor installation using the adjustable feet or ceiling
mounting installation using the Ceiling Mount Bracket, remove the four adjustable feet and use the six screw
holes (as shown in the figure) to fix the projector to a mount.
f Use a torque screwdriver or Allen torque wrench to tighten the fixing screws to their specified tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
(Screw diameter: M6, tapping depth inside the projector: 27 mm (1-1/16"), screw tightening torque: 4 ± 0.5 N·m)
Unit: mm
Adjustable feet
Adjustable feet
Positions of screw holes to fix projector and
adjustable feet
22 - ENGLISH
Chapter 1 Preparation — Precautions for use
Screw holes to fix the projector
M6
M6
Screw tightening torque: (M6) 4 ± 0.5 N·m
Thread engagement depth
Mount
Embedded nut (thread
engagement depth)
Screw hole maximum
depth
Embedded nut
Advertisement
Table of Contents
