Table of Contents
Advertisement
r [CONTENT INFORMATION]
[EOTF]
[MASTERING DISPLAY
COLOR VOLUME]
[CONTENT LIGHT LEVEL]
Note
f The content of the status can be sent to the E-mail address (up to two addresses) set in "[E-mail set up] page" (x page 221) when the
<ENTER> button is pressed while displaying the pages 1/6 to 5/6 of the [STATUS] screen.
f If you press the <ENTER> button while displaying [SIGNAL INFORMATION] in the page 6/6 of the [STATUS] screen, the [DETAILED
INFORMATION] screen can be displayed to view the detailed information of the input signal. Information for multiple input signals may be
displayed depending on the projected image. Press qw to switch pages.
f While the [DETAILED INFORMATION] screen is displayed, press the <ENTER> button to display the [CONTENT INFORMATION] screen,
and the contents of the InfoFrame information added to the input signal can be displayed.
f There are items that are displayed or not displayed in [SIGNAL INFORMATION], [DETAILED INFORMATION], and [CONTENT
INFORMATION] depending on the setting and the signal being input.
f If any abnormality has occurred on the projector, press the <DEFAULT> button while the [STATUS] screen is displayed to display the detail
screen of the error information.
f For details on the contents displayed in [SELF TEST], refer to "Self-diagnosis display" (x page 235).
[AC VOLTAGE MONITOR]
Enable or disable the AC voltage monitor function. The value of input supply voltage is displayed on the self-
diagnosis display at the side of the projector when enabled.
1)
Press as to select [AC VOLTAGE MONITOR].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f When [ON] is set, the value of the input supply voltage is always displayed in the self-diagnosis display while the main power of the projector
is turned on.
f Even when [OFF] is set, the value of input supply voltage can be displayed temporarily in the self-diagnosis display by operating the button
on the remote control. (x page 92)
f The value of input supply voltage cannot be displayed in the self-diagnosis display during standby when the [PROJECTOR SETUP] menu
→ [STANDBY MODE] (x page 176) is set to [ECO].
[SAVE ALL USER DATA]
Save the various setting values as a backup in the built-in memory of the projector.
1)
Press as to select [SAVE ALL USER DATA].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
f The confirmation screen is displayed.
188 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Displays EOTF (Electro-Optical Transfer Function) out of the InfoFrame information added to the
input signal.
[RED]
[GREEN]
[BLUE]
[WHITE]
[MAX LUMINANCE]
[MIN LUMINANCE]
[MaxCLL]
[MaxFALL]
Disables the AC voltage monitor function.
Enables the AC voltage monitor function.
Displays the chromaticity coordinates for the primary color red out
of the InfoFrame information added to the input signal.
Displays the chromaticity coordinates for the primary color green
out of the InfoFrame information added to the input signal.
Displays the chromaticity coordinates for the primary color blue out
of the InfoFrame information added to the input signal.
Displays the chromaticity coordinates for the white point out of the
InfoFrame information added to the input signal.
Displays the maximum brightness out of the InfoFrame information
added to the input signal.
Displays the minimum brightness out of the InfoFrame information
added to the input signal.
Displays MaxCLL (Maximum Content Light Level) out of the
InfoFrame information added to the input signal.
Displays MaxFALL (Maximum Frame Average Light Level) out of
the InfoFrame information added to the input signal.
Advertisement
Table of Contents
