Lexmark MX717 User Manual page 162

Understanding the printer menus
Use
Enable RARP
On
Off
Enable BOOTP
On
Off
Enable AutoIP
Yes
No
Enable FTP/TFTP
Yes
No
Enable HTTP Server
Yes
No
WINS Server Address
Enable DDNS
Yes
No
Enable mDNS
Yes
No
DNS Server Address
Backup DNS Server Address
Backup DNS Server Address 2
Backup DNS Server Address 3
Enable HTTPS
Yes
No
IPv6 menu
To access the menu, navigate to any of the following:
•
Network/Ports menu > Standard Network > Standard Network Setup > IPv6
•
Network/Ports menu > Network [x] > Network [x] Setup > IPv6
Note: This menu is available only in network printers or printers that are attached to print servers.
Use
Enable IPv6
On
Off
To
Specify the RARP address assignment setting.
Note: Off is the factory default setting.
Specify the BOOTP address assignment setting.
Note: On is the factory default setting.
Specify the Zero Configuration Networking setting.
Note: Yes is the factory default setting.
Enable the built-in FTP server, which lets you send files to the printer using File
Transfer Protocol.
Note: Yes is the factory default setting.
Enable the built-in Web server (Embedded Web Server). When enabled, the
printer can be monitored and managed remotely using a Web browser.
Note: Yes is the factory default setting.
View or change the current WINS server address.
View or change the current DDNS setting.
Note: Yes is the factory default setting.
View or change the current mDNS setting.
Note: Yes is the factory default setting.
View or change the current DNS server address.
View or change the backup DNS server addresses.
View or change the current HTTPS setting.
Note: Yes is the factory default setting.
To
Enable IPv6 in the printer.
Note: On is the factory default setting.
162